Disassembly and Reassembly
Samsung Electronics
Service Manual
5-29
5.21 Pick Up Roller
1. Before you remove the Pick Up Roller, you should
remove:
- HVPS (Refer to 5.14)
- LIU Unit (Refer to 5.15)
- Shield Main Lower(with Main PBA) (Refer to 5.16)
- Main Drive Ass'y (Refer to 5.17)
2. Remove the two screws securing the Bracket and
remove it, as shown below.
3. Remove the three screws securing the Pick Up
Plate(with Pick Up Guide) and then release the Pick
Up Plate in the direction of arrow.
4. If necessary, remove the two screws securing the Pick
Up Plate and remove it from the Pick Up Guide, as
shown below.
5. If necnssary, pull the Pad Holder from the Pick Up
Guide, as shown below.
Notice: 1) Be aware of the Springs to ensure they are
not lost.
2) Clean the surface of the Rubber Pad with
ethylalcohol.After wiping, be sure to dry it.
To Next Page
Loading...
