1. Before you remove the Platen Ass'y, you should
remove:
- OPE Unit (Refer to 5.8)
- Side Cover Left, Right (Refer to 5.9)
- ADF Ass'y (Refer to 5.10)
2. Remove the three screws securing the Platen Ass'y,
as shown below.
3. First carefully release the cables(CCD, Scan, Ground)
from the Harness Guide and then apply light pressure
to the top of the Harness Guide and pull it to the right
side in the direction of arrow, as shown below.
4. First release the OPE Harness in the direction of
arrow and then remove the one screw securing the
Ground Cable, as shown below.
5. Unplug the two connectors(Scan, Out Full) and CCD
Cable and then lift the Platen Ass'y in the direction of
arrow, as shown below.
To Next Page
Loading...
