53
Setting up the play back function by using the camera button
PLAY MODE
You can set up the PLAY mode function by using the camera buttons.
Power switch
Used for turning the camera power on / off.
If this camera doesn't be operated during the specified time(about 60 SEC.), the camera power will
be idle(LCD monitor off, Camera status LED : Green) automatically(p.71). To use the camera again,
press the camera buttons except the power switch.
The camera power will be turned off automatically during periods of inactivity. This is done to reduce
battery drain. The camera can be reactivated by sliding the power switch again.
Shutter button
Pressing the shutter button in normal play back mode applies the DPOF(number of print : 1) function
to a still image that is stored only in the CARD.
DPOF icon( ) will be displayed on the LCD monitor.
LCD button
Pressing the LCD button in the PLAY mode will change the display as shown below.
TV : Shutter speed
AV : Aperture value
image & basic information
image & full information
Pressing the
LCD button
Pressing the
LCD button
ADVANCED
To Next Page
Loading...
