Samsung FER710DRS - Page 37

37
4. Troubleshooting
-dE-
* Disconnect power.
* Get rid of harness connected with partition
switch.
* Measure resistance of partition switch.
aȍ
* Check whether harness connected
normally into CN401 of main PCB.
Ok
Ok
No
No
No
* Measure resistance CN401 of main pcb.
SLQSLQ
* Replace partition switch.
* Repair damaged harness or replace.
END
END
END
* Replace main PCB.
* Solder again if pattern is damaged
or parts is wrong contacted.
END
Partition Switch
CN401
4-1 Failure Display Codes