Samsung FER710DRS - Page 38

38
4. Troubleshooting
E-2E
* Disconnect power.
* Get rid of harness connected with Meat probe.
* Check whether harness connected normally
into CN401 of main PCB.
0HDVXUHUHVLVWDQFHRI0HDWSUREH
* Measure resistance CN401 of main PCB.
(pin.6-pin.7 : 10㏀ ~ 11㏀
END
Ok
No
No
No
Ok
Ok
* Replace Meat probe.
* Replace Meat probe.
* Replace Meat probe.
END
END
END
CN401
< Meat Probe >
4-1 Failure Display Codes