Samsung FER710DRS - User Manual

54 pages

Save Page as PDF

To Next Page

Refer to the service manual in the GSPN(see rear cover) for the more information.

1. Precaution

3. Disassembly and Reassembly

4. Troubleshooting

5. PCB Diagrams

6. Wiring Diagram

SLIDE IN RANGE

FREE STANDING RANGE

BASIC: FER710DRS

MODEL: NE58F9710WS

MODEL CODE:

NE58F9710WS/AC

Main Page

Questions and Answers

M
Megan AlvaradoAug 29, 2025
What to do if the oven door will not open after a self-cleaning cycle on my Samsung FER710DRS Ranges?
- K
  Kelly MatthewsAug 30, 2025
  If the oven door on your Samsung Ranges won't open after a self-cleaning cycle, it's likely because the oven is still too hot. Allow the oven to cool down completely before attempting to open the door.
M
martinezlauraAug 28, 2025
Why does food dry out in the warming drawer of my Samsung Ranges?
- S
  susanortizAug 28, 2025
  If food is drying out in the warming drawer of your Samsung Ranges, it may be due to moisture escaping. Make sure to cover the food with a lid to retain moisture. Also, ensure that the drawer is fully closed so the latch engages properly.
G
galvansonyaAug 27, 2025
Why Samsung Ranges surface units will not maintain a rolling boil?
- C
  Charles LaneAug 27, 2025
  If the surface units on your Samsung Ranges aren't maintaining a rolling boil or cooking food fast enough, make sure you're using flat pans that match the diameter of the surface unit. If the power (voltage) in your area is low, cover the pan with a lid to help retain heat until the desired temperature is reached.
M
martinezbrendaAug 27, 2025
What to do if my Samsung FER710DRS oven control beeps and displays an error code?
- G
  gentrychadAug 27, 2025
  If your Samsung Ranges oven control is beeping and displaying an error code, press Oven Off and restart the oven. If the issue continues, disconnect the power to the range for at least 30 seconds, then reconnect it. If the problem persists after this, call for service.
G
gwhiteAug 26, 2025
Why does the display go blank on my Samsung FER710DRS?
- J
  Jason SimsAug 26, 2025
  If the display on your Samsung Ranges goes blank, a fuse in your home may be blown, or the circuit breaker may have tripped. Replace the fuse or reset the circuit breaker.
J
James WilliamsAug 25, 2025
What to do if my Samsung Ranges oven will not turn on?
- C
  Cynthia BaldwinAug 25, 2025
  If your Samsung Ranges oven isn't turning on, ensure the range is fully plugged into a working, grounded electrical outlet. Check your home's fuse box or circuit breaker and replace any blown fuses or reset tripped breakers. Also, verify that the oven controls are properly set. Finally, if the oven is too hot, allow it to cool down before attempting to turn it on.