Note: Make sure that you have not
loaded too much print media. The stack
should be under the stack height limit
mark. The print media buckles if you load
a stack that is too deep, or push it in too
far.
4.9
PRINT MEDIA
Loading Paper
4
Place paper with the print side face
up, and against the left edge of the
tray.
5
Slide the paper width guide to the left
flush against the stack of print material
without bending.
Stack height limit mark
6
After printing, push the extender back
to its place and close the Multi-Purpose
Tray.
To Next Page
Loading...
