Selecting the Fan Mode
Select the fan mode to circulate air without changing the
temperature.
1
Press the (ON/OFF) button to turn on the indoor unit.
- Do not press the
(ON/OFF) button if the remote
controller is on.
Result
: The air conditioner will be turned on with the
most recently used mode.
Caution The air conditioner has a built-in protection
mechanism to prevent the unit from being
damaged when it is started immediately after
being:
Plugged in
Stopped
The air conditioner will start up after 3 minutes.
2
To select the FAN mode, press the button until Fan is
displayed on the remote controller.
Result
: The air conditioner will operate in fan mode.
You cannot adjust the temperature in fan
mode.
3
Select the fan speed by pressing the button.
Result
: Each time the button is pressed, fan speed will
change in the following order:
Low
Med
High
4
To adjust the air swing direction, refer to page 13.
To Next Page
Loading...
