Failed Wired Connection
No network cable found
Try Now
Try Now
Make sure the network cable is plugged in. If it is connected, make sure the router is turned on. If it is
on, try turning if off and on again.
IP auto setting failed
Try Now
Perform the following or set the IP address manually from IP Settings.
1.
Ensure that the DHCP server is enabled on the router and reset the router.
2.
If this does not work, contact your Internet Service Provider for more information.
Unable to connect to the network
Try Now
Check the following:
1.
Check the IP Settings.
2.
Ensure that the DHCP server is enabled on the router and unplug and then plug the router back in.
3.
If this does not work, contact your Internet Service Provider for more information.
Connected to a local network, but not to the Internet
Try Now
1.
Make sure that the Internet LAN cable is connected to the router's external LAN port.
2.
Check the DNS settings under IP Settings.
3.
If the problem persists, contact your Internet Service Provider.
Network setup complete, but unable to connect to the Internet
Try Now
If the problem persists, contact your Internet Service Provider.
To Next Page
Loading...
