68
Manual Network Setup (Wireless)
Offices may use static IP addresses.
DNS server address. Enter these values manually.
Getting the Network Connection Values
To view the Network connection values on most Windows computers, follow these steps.
1
2
In the pop-up menu that appears, click Status.
3
On the dialog that appears, click the Support
4
On the SupportDetails
How to set up manually
1
Set Network Type to Wireless from the Open Network Settings page.
2
The Network
3
In the list of networks, press the u or dE
"
If the desired wireless router does not appear, select Refresh to search again.
"
Stop
The Add Network
4
If the Enter the password for (AP Name). screen appears, go to step 5. If you select a
wireless router that does not have security, go to step 7.
5
If the router has security, enter the Enter the password for (AP Name). (Security key or PIN).
6
Done, and then press E. The
network connection screen appears and the verification process starts.
7
Select Cancel
connection.
8
Select IP Settings on network connection screen. The IP Settings screen appears.
9
Select the field at the top, press E, and then set IP setting to Enter manually. Repeat the
entry process for each field in the IP Address.
"
Setting IP setting to Enter manually automatically changes DNS setting to Enter
manually.
10
When done, select OKE. The network test
screen appears and the verification process starts.
11
Success! Your device is connected to the
Internet. If you have any problems using online services, please contact your Internet
service provider.” message appears.
To Next Page
Loading...
