76
Standby Control
Auto
Power-saving mode will activate if no input signals are detected even though a source device is connected to
the display.
The message No Signal will appear if no source device is connected.
Off
The message No Signal will appear if no input signals are detected.
"
If No Signal
"
If No Signal Message is set to Off, the No Signal message does not appear.
If this is the case, set No Signal Message to On.
On
Power-saving mode will activate if no input signals are detected.
Network Standby
This feature keeps the network power on when the product turns off.
Off / On
Power Button
Power on only
Power on and off
Power Control
Auto Power On
PC module power
Max. Power Saving
Power Button
Off
On
On
Off
Power on only
"
The displayed image may differ depending on the model.
To Next Page
Loading...
