Samsung SCB-9050 - Function Settings Adjustment Methods; Brightness and Contrast Settings

Thermal Night Vision Camera User Guide
20
Thermal Night Vision Camera User Guide
21
MAIN SETUP
1. BRIGHTNESS AUTO
2. CONTRAST MANUAL
MAIN SETUP
1. BRIGHTNESS AUTO
2. CONTRAST MANUAL
3. RANGE AUTO
Operating the Camera
BRIGHTNESS
CONTRAST
1.PresstheSETbuttonwhilethecursorisalignedwith“1.
BRIGHTNESS”todisplaytheBRIGHTNESSsubmenushown
below.PresstheLEFTbuttonorRIGHTbuttonwhilethecursoris
alignedwith“AUTO”toswitchtheBRIGHTNESSAUTOADJUST
setting from : ONOFFON.
 PresstheLEFTbuttonorRIGHTbuttonwhilethecursorisaligned
with“MANUAL”toadjusttheBRIGHTNESSovertendifferent
levels: 1  2 3  4  5  6 7 8  9 10 
1.Select“2.RETURN”toconfirmthecurrentsettingandgo
backtotheMAINSETUPmenuscreen.(Defaultvalue:AUTOON)
2. PresstheSETbuttonwhilethecursorisalignedwith“2.
CONTRAST”todisplaythefollowingsubmenu.PresstheLEFT
buttonorRIGHTbuttonwhilethecursorisalignedwith“AUTO”
toswitchtheCONTRASTAUTOADJUSTsettingfrom:ON 
OFF  ON.
BRIGHTNESS
▶ 1.MANUAL 5
2.RETURN
CONTRAST
▶ 1.MANUAL 6
2.RETURN
Functionsettingsmaybeadjustedusingtheinternalswitchesafterremovingtherear
cover.(Referto“5.Interface”fordirectionsonhowtoremovetherearcover.)
UP button : Move the menu cursor up.
RIGHTbutton:Increase(+)thesettingsvalueoftheselecteditem.
DOWN Key : Move the menu cursor down.
LEFTbutton :Decrease(-)thesettingsvalueoftheselecteditem.
SETbutton :Ifa“ ”iconisdisplayed:Movetoascreenwhereyoucanselectsettings
values (move down a level)
If a “ ”iconisnotdisplayed:Executeoradjusttheselecteditem
PresstheSETbuttontodisplaytheMAINSETUPmenuscreen.TheMAINSETUPmenu
uses a tree structure. When you select a function, a sub menu will appear.
UP
SET (Push)
RIGHT
DOWN
LEFT
< Control buttons >
Function Settings Methods
MAIN SETUP
1. BRIGHTNESS AUTO
2. CONTRAST MANUAL
3. RANGE AUTO
4. NUC
5. NUC MOOE INTERVAL
6. IMAGE ADJ
7. SPECIAL
8. SAVE
9. EXIT
Use the UP button or DOWN
button to select the item you
would like to set.
UsetheRIGHTbuttonorLEFT
button to change the status of
the corresponding setting.