Samsung SCB-9050 - Troubleshooting; Problem Diagnosis and Solutions

Thermal Night Vision Camera User Guide
30
Thermal Night Vision Camera User Guide
31
SCB-9050
SCB-9051
Ø104
352
123
104
Ø104
367
123
104
Dimension
* RS485 Communication Settings Default Values
Item Camera No.
Communications
Speed
Communications
Mode
Data Reception
Default Value 1 9600 8-EVEN -1 In use
Check the points listed below if the product appears to be malfunctioning. If the problem
continues, please contact the sales agent from whom the product was purchased.
• If nothing can be seen onscreen :
- Verify that the power source is connected properly, and that the device is receiving power.
- Verify that the video signal wire is connected properly.
• If screen images do not appear clearly :
- Wipe the lens with a clean cloth or brush to remove any dust that may be present.
 -Adjustthestatusofthemonitor.
- Change the position or angle of the camera if a large amount of bright light is displayed onscreen.
• If the screen is too dark :
 -Adjustthestatusofthemonitor.
- Verify that intermediate processing can be performed properly between systems.
• If the camera is operating abnormally, or its surface is very hot, causing black lines to appear
onscreen :
- Verify that the power voltage received by the camera conforms to the proper rating. Also, confirm
whether performance is affected by the time of day.
• If RS485 communications cannot be carried out :
- Verify the polarity of the RS485 communications terminal and the arrangement of the cables.
- Verify the RS485 communications settings.
Troubleshooting