Samsung SCB-9050 - Installing the Camera; RS485 Communications Setup; Monitoring Guidelines and Storage

Thermal Night Vision Camera User Guide
14
Thermal Night Vision Camera User Guide
15
Interface
Attach the lens cap before storing this device.
Ensure that the storage area is kept within the allowable temperature range listed in this
device’sproductspecifications.Donotplacethisdeviceinalocationwherecondensation
may occur.
A user interface terminal block is attached to the inside of this device.
Aftermakingadjustmentstotheinternalterminalblock,ensurethatthebackcoveris
properly attached.
3.AlwayscarryoutanNUCwheneversunlightorhightemperatureobjectsarewithinthe
field of view.
4. When the camera is used continuously for a long period of time, pay attention to the
buildup of dirt on the lens. A dirty lens may result in phenomena such as shortened
detection distances.
5. Even if the same item is being monitored, changes in environmental conditions such as
rain and fog will affect detection distance. While operating the camera be aware of how
such changes may influence detection distance.
External communications cable RS485 control terminal
(+) CONNECTION TERMINAL (TRX+) 485+
(-) CONNECTION TERMINAL (TRX-) 485-
Storage
Installing the Camera
UsingRS485communications,functionsettingsmenuscanbeadjustedusingtheSamsung
TechwinDVRorSystemcontroller.
(1) Controlling menus using a PC
Using an RS485 converter, connect the camera's RS485 control terminal to a serial cable.
Example) PC serial board (COM1)  serial cable  RS485 converter  camera RS485 control
terminal
(2) Controlling menus using a DVR system controller
ConnectanRS485cable(TRX+,TRX-)toanRS485controlboardconnectionterminalcapableof
connecting to the DVR system controller.
■RS485 Communications Controls
Communications Settings Default Values (camera default values at the time of shipment)
• Please use Samsung Techwin Protocol or Pelco-D Protocol when controlling the camera
with a separate controller.
Notes
• Leakage may occur if the back cover is not properly attached.
Notes
After thermal images appear, the camera will begin to monitor its range of coverage.
1.Donotadjustthefocusifthereisnoparticularpointoffocustomonitor.
2. For an in-depth explanation of the controls used with the SCB-9050/9051, refer to the
section detailing how the camera is operated on page 16.
During monitoring, the SCB-9050/9051 will capture heat sources and display the resulting
images on the monitor.
1.Ifthesubjectenvironmentexperiencesadramaticchangeintemperatureduring
monitoring,besuretosetNUCMODEtoeitheranINTERVALof10MINorless,oranAMB
of 1.0°C or lower .
2. Please be aware that because this is an infrared camera, reflections not visible to the
naked eye may still be displayed. Images reflected off glass or mirrors located in front of
the camera may become visible.
Interface
Monitoring Guidelines