4.1.4 EDC mode
4.1.4.1 Entering the EDC mode
In EDC mode, the technician can check the particular component of the printer are properly functioning
■ Method to enter
1. Connect only one printer to the computer using USB cable.
2. Power up the printer and wait for the printer to nish initializing.
3. Start EDC utility, see page 66.
4. To get out of the EDC Mode, Press the “Exit” button.
* Allow 1 second for the printer to process the command from EDC before pressing then next button.
■ Menu Map
0. Check Cover Status
1. Check Sensor Status
2. Test Motor
3. Test Fan
4. Test Clutch & Solenoid
5. Fuser Control
6. LSU Control
7. DEV Control
To Next Page
Loading...
