Samsung SCX-6555N - Page 167

Alignment & Troubleshooting
Service Manual
4-67
Samsung Electronics
Code NVM Description Meaning Component Default
Maximum /
Minimum
10-155 Labels Temperature
offset
Media type offset for fuser roll temperature. Engine 5 0 ~ 10 (3 steps / 5
degrees interval)
10-200 Fuser Life Page Counter [Read Only]Total fuser page count Engine 0 Read Only
10-210 Heat Roll Life Page
Counter
[Read Only]Heat roll page count Engine 0 Read Only
10-220 Pressure Roll Life Page
Counter
[Read Only]Pressure roll page count Engine 0 Read Only
10-300 Pick-up interval delay Change time interval for paper pick-up Engine 0 0 ~ 100 ( * 100
msec )
10-310 Pick-up interval delay
[Special paper]
Change time interval for paper pick-up Engine 0 0 ~ 100 ( * 100
msec )
117-0001 Print CTD Check Page Print CTD Check Page
2) Print Margin
Code NVM Description Meaning Component Default
Maximum /
Minimum
07-100 Top Registration Tray1
Simplex
The changed dimension of Tray1 Top Registration
in Simplex
Engine 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-200 Top Registration Tray2
Simplex
The changed dimension of Tray2 Top Registration
in Simplex
Engine 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-300 Top Registration Tray3
Simplex
The changed dimension of Tray3 Top Registration
in Simplex
Engine 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-400 Top Registration Tray4
Simplex
The changed dimension of Tray4 Top Registration
in Simplex
Engine 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-500 Top Registration Bypass
Simplex
The changed dimension of Bypass Top
Registration in Simplex
Engine 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-110 Side Registration Tray1
Simplex
The changed dimension of Tray1 Side Registration
in Simplex
Print 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-210 Side Registration Tray2
Simplex
The changed dimension of Tray2 Side Registration
in Simplex
Print 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-310 Side Registration Tray3
Simplex
The changed dimension of Tray3 Side Registration
in Simplex
Print 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-410 Side Registration Tray4
Simplex
The changed dimension of Tray4 Side Registration
in Simplex
Print 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-510 Side Registration
Bypass Simplex
The changed dimension of Bypass Side
Registration in Simplex
Print 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-120 Top Registration Tray1
Dup_long (2nd side)
The changed dimension of Tray1 Top Registration
of 2nd side in Duplex long
Engine 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
07-220 Top Registration Tray2
Dup_long (2nd side)
The changed dimension of Tray2 Top Registration
of 2nd side in Duplex long
Engine 30 0 ~ 60mm (12 Steps
/ 5mm Seg.)
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA