Check where the jammed paper is
located
Check where the jammed paper is
located
Paper still inside the
Tray ?
Pull out the tray and start the printing job with
Leg -M_Act No Paper on by lift upside.
Check if the MEA Unit - Roller PU is rolling or not
Does the MEA Unit -
Roller PU rotate?
Replace the MEA Unit - Cassette or the MEA
Unit -Roller PU
Check if any object or obstruction is on
the path before the forward roller. If any,
remove it or them.
Check the Clutch -5K Z32 and the Motor DC -
Main work or not. If needed, replace them.
Check if the Photo Interrupter(Registration Sensor)
works or not
- You can make sure of it by actuating the Leg - M_Act
Ready DP. If it does not work, replace the HVPS -
Jungfrau.
End
End
End
End
Yes
Yes
OK
NO
NO
NO
OK
OK
OK
To Next Page
Loading...
