Samsung SNP-6320RH User Manual

installation & connection
28_ installation & connection
INSERTING/REMOVING A SD MEMORY CARD
J
`
Disconnect the power cable from the camera before inserting the SD memory card.
`
Tighten the screws when assembling the camera body, shield cover and SD holder bracket to
prevent moisture penetration.
`
When mounting or dismounting an SD memory card, place the main body on the floor first to
prevent part loss and falling accident.
Inserting a SD Memory Card
1. Separate with hands the screws in front of and on
the rear of the shield cover.
2. Unfasten four screws by turning them
counterclockwise using a driver to separate the
shield cover.
3. Unfasten two screws on the SD holder bracket by
turning them counterclockwise using the driver.
J
`
Do not remove the screws.

Samsung SNP-6320RH Specifications

General

Resolution	1920 x 1080
Connectivity Technology	Wired
Form Factor	Dome
Optical Zoom	32x
Digital Zoom	16x
Pan Range	360° endless
Ingress Protection	IP66
Vandal Proof	IK10
Video Compression	H.264, MJPEG
Signal-to-Noise Ratio	50 dB
Lens	Varifocal
Device Type	PTZ dome camera
Infrared Distance	150m (492ft)
Sensor Size	1/2.8 inch
Tilt Range	190°
Protocols	TCP/IP, UDP/IP, RTP/RTSP, HTTP, HTTPS, FTP, SMTP, DHCP, PPPoE, DDNS, NTP, UPnP, Bonjour, ONVIF
Power Source	AC 24V, PoE+
Network Interface	RJ45
Operating Temperature	-50°C ~ +55°C (-58°F ~ +131°F)
Sensor	CMOS
Minimum Illumination	0 Lux (IR LED on)
Power Supply	PoE+ (IEEE 802.3at), 24V AC