English _19
● INSTALLATION & CONNECTION
Flushed installation on the ceiling
1. Using the provided template, drill a hole for the camera unit and fixing holes (diameter
5mm, more than 35mm deep) on the ceiling. Insert the plastic anchors (HUR-5) fully
into the fixing holes.
2. Separate the dome cover and case.
For separating dome cover and case, refer to the “Installing on the ceiling directly”.
3. Connect power and video cables and arrange cable running not to damage or
squeeze them.
4. Remove the case assembly screws from the
camera module.
5. Insert the camera module into the camera
hole, and install it by fastening the Tapping
Screws (TH, M4xL30) by matching the fixing
holes (3 places).
6. Assemble the Dome Cover.
Refer to the “Installing on the ceiling di-
rectly”.
To Next Page
Loading...
