camera setup
50_ camera setup
MOTION
You can set the level for automatic gain control
(AGC) for the motion control of camera.
Select the <F.FAST> to monitor the fast moving
subject in dark lighting condition; and select
the <S.SLOW> to monitor the subject without
moving in dark lighting condition.
If you select the <AUTO> for DAY/NIGHT, you cannot
use the <MOTION> menu.
DNR
You can set to reduce the noise in the screen.
SHUTTER
You can set fixed high-speed electronic shutter and automatic high-speed electronic shutter.
SENS-UP
You can set the automatic low-speed shutter function to be activated if the luminance of
video signal is too low.
FLICKERLESS
You can set to prevent the screen from flickering caused by inconsistency between the
vertical sync frequency (VSF) and the flicker frequency of lighting.
You can fix the shutter speed to 1/100 sec. by selecting <ON>.
XDR
You can set the camera to calculate and compensate the luminance contrast if the
shooting place has some brightness contrast.
DAY/NIGHT
You can set the suitable mode for shooting environment.
1. Select the <DAY/NIGHT>.
2. Select the screen mode to switch by illumi-
nance and set the sub-menu.
DAY : The shooting mode is fixed to
DAY mode regardless of shooting envi-
ronment change.
NIGHT : The shooting mode is fixed to
NIGHT mode regardless of shooting
environment change.
If you select <ON> for BURST, the burst signal is output.
To Next Page
Loading...
