Samsung SNV-3120 - Page 66

setup screen
66_ setup screen
To make recording on the SD memory
1. Check the <Total size> and the <Free size>.
2.
If the SD memory has a sufficient free space, set <Record> to <On>.
Otherwise, check the stored data and if you find them not important, then click
<Format> to format the SD memory.

If your SD memory card writes slowly, only one frame per second will be stored.

For a SD memory card with a large capacity, the formatting will be slowed down accordingly.

If the size of data grows with time, only 1 fps can be stored even if you set the record quality to Full
Frame.
3. Specify the record conditions.

Record 1 fps forcibly : Only one frame per second will be recorded regardless of
the existing record profile.

Overwrite : If the SD memory is full, this will delete old data and store new data in
replacement.

Pre-alarm duration : Specify the time point before the occurrence of the alarm;
starting from the time point, the images will be transferred. You can specify up to
5 seconds before the occurrence of the alarm.

Post-alarm duration : Specify the time point after the occurrence of the alarm; to
the specified time point, the images will be transferred. You can specify up to 120
seconds after the occurrence of the alarm.
4. When done, click [Apply (
)].