10_ overview
overview
PART NAMES AND FUNCTIONS (REAR)
Part Names Functions
VIDEO IN Input port for the composite video signal.
b
VIDEO OUT (SPOT) BNC type of output port for the composite video signal.
c
AUDIO IN Input ports (RCA) for the audio signal.
VGA Output port for VGA video signal.
NETWORK NETWORK connector port.
DC 12V DVR power input port.
ALARM IN 1~4, G : Alarm Input port.
ALARM OUT 1, COM : Alarm Output port.
RS-485 Used to establish RS-485 communications.
USB USB connector port.
SERIAL Serial port for connecting to a POS device.
AUDIO OUT Output port (RCA) for the audio signal.
M
[CONSOLE] is designed for the service repair purpose only.
If you want to change the default output to VGA mode when the live screen is displayed with the beep after the
system booting, press the remote control buttons in sequence: [FREEZE] [VIEW] [RETURN (
)]
[FREEZE] [VIEW] [RETURN ( )]. The DVR will switch to VGA mode with the beep after rebooting.
For more information about monitor output, refer to “Video Output”. (Page 48)
SERIAL
VGA
NETWORK
12
USB DC 12V
AUDIO IN
AUDIO OUTVIDEO OUT
(SPOT)
VIDEO IN
3 4GG 1 COM
ALARM
IN
ALARM
OUT
RS-485
CONSOLE
b c
To Next Page
Loading...
