77
5.1. System
On the default LCD screen, press ∧, ∨ to move to the screen shown below and press
ENTER.
Sub-menus will appear where you can use the ∧, ∨ buttons to navigate.
5.1.1. Checking Firmware Version
Under System, select 1. Firmware Version, and then press Enter. The current firmware version
of the system displays as shown in the illustration below.
Below is a sample picture provided for your reference; the firmware version differs depending
on the model.
5.1.2. Turning On/Off Beep
You can turn the beep of the front panel buttons on or off using this menu item.
Under System, select 2. Key Beep On/Off, and then press ENTER.
Selecting "1. On" and pressing Enter turns on the beep. Selecting "2. Off" and pressing Enter
turns off the beepIn each case, the following messages appear.
7. System Power Off
Key Beep is Off!
Key Beep is On!
1. On
2. Off
Firmware Version
0.1.4-090309
5. Factory Reset
6. Test HDD
3. Relay off
4. System Update
1. Firmware Version
2. Key Beep On/Off
1. System
[SET]
To Next Page
Loading...
