80
For more information about the default settings value, please refer to "2.3. Default Settings"
Note
The Factory Reset does not reset the RAID settings of the system or delete data
saved in the HDDs.
5.1.6. HDD Check
Under System, select 6. Test HDD, then press Enter. The following messages appear asking
you to select an HDD to check.
Selecting an HDD displays a message asking if you really want to perform disk-checking for
the selected HDD.
When pressing ENTER, the following message appears as the disk-checking process is
initiated. Once the process is complete, the screen displays the check results.
The check results stay on the screen until you click a button.
When selecting an HDD that is not available or connected, the following message appears.
HDD test result:
0 bad block
Are you sure?
Yes: Enter No: Esc
Record on this HDD
will be stopped
Examining Int HDD[1]
[DONE]
Examining Int HDD[1]
is in Pro
To Next Page
Loading...
