Samsung SVR-1680 - Basic System Mode; User Sequence Mode

User Manual
25
4.4.1 Basic System Mode
- Pressing the [AUTO] button or clicking in the function menu will cause the DVR to
cycle through the set channels.
- Press [MENU] button or click
in the function menu to set up sequence period.
- Go to “Screen Setup” from OSD menu.
- Go to “Monitor” under “Screen Setup”, and press [ENTER] button or left-click.
- Select “SEQ. Dwell Time” and assign the desired value ranging from 1 to 60. When set to
Off, user sequence view function will not operate.
- User sequence mode can be accessed by pressing [AUTO] button from every partition
mode.
- Press [AUTO] button once again to exit from user sequence mode.
4.4.2 User Sequence Mode
- Press [AUTO] button or click from the function menu.
- To activate user sequence, set “Monitor” to User Sequence in the OSD menu.