User Manual
54
MD
Motion detection is used to detect changes in motion in all or individual channels and to
trigger events.
- Channel
Channel can be set to All or as follows:
SVR-3200 : 1 - 32CH
SVR-1680/1660/1645 : 1 - 16CH
SVR-960/945 : 1 - 9CH
- Sensitivity
There are 12 levels of detection sensitivity: Min, 1 - 10, Max.
- Area
Area defines a section on the screen where changes in motion will be detected. If Channel is
set to All, the available options are Apply to All and Disengage All. If Channel is set to individual
channels, the available options are Apply to All, Disengage All and Custom.
- Select Area
Select Area is used to define the section where motion detection function will focus on for
individual channels. The screen is divided into 22x15 in NTSC and 22x18 in PAL. The MD
area must contain more than one square.
The default value for this option is "Select All". Select "Define Area" to prompt the MD Area
Definition window.
The MD area can be drawn directly on the screen by the user.
A selection grid of 22x15 partitions for NTSC and 22x18 partitions for PAL will appear.
To Next Page
Loading...
