When the DVR system time is reset or mismatched, the message below is displayed. This message is
displayed when the DVR system time is set to before of the time recording data on the HDD. If the DVR
system time is set correctly, the DVR will not show the 'TIME MISMATCH' error message.
① When the above message is displayed, power the system OFF. Please the power the system ON,
pressing the ESC button. (Press the ESC button and hold it until the initial message is displayed on
the screen as below.) Then the system will ask whether to enter into the DVR DIAGNOSTICS MENU.
If the user selects [YES], the DVR DIAGNOSTICS MENU will be started. When the password is pre-set,
the password window is displayed.
② Select 'RTC Configuration'. The picture below is displayed.
5.14.2 Index Start Fail
Chapter 5. Conguration
To Next Page
Loading...
