4. Connect the E-IDE & power cables.
5. In case of installing two Hard Disk Drives.
Check the "MASTER" or "SLAVE" on the SATA converter board.
Connect to the power(SMPS) using power cable. (1st HDD - the main power cable, 2nd
HDD - the sub power cable)
When you use two HDDs, HDDs should be same model and have same interface.
Connect with E-IDE HDD cable and power cable.
a. Direction of the SATA Converter board
b. Direction of the main power
Sub-power cable for SATA Converter board
Connect to the power cable Connect to the E-IDE HDD cable
To Next Page
Loading...
