Copyright© 1995-2012 SAMSUNG. All rights reserved. 3-193-19
Disassembly and reassembly
Fig. 3-35
3. Lubricating with HANARL: Others components
Apply the HANARL to the Inside and outside friction surface of the components such as ZOOMRING,
CAM BARREL, GUIDE PLATE as illustrated in image below.
■
Make sure to shake the HANARL well rst before you use it until there are no lumps.
■
Apply the HANARL with a clean and good-quality brush, making sure the surface is clean.
■
HANARL is volatile product. Keep its container tightly covered.
CAUTION
!
BARREL-OUTER GUIDE
BARREL-OUTER CAM
Around the outside friction surface
Inside surface thoroughly
Inside surface thoroughly
To Next Page
Loading...
