Samsung WB200F - 8 Adjustment; Basic Guide for Adjustment

Copyright© 1995-2012 SAMSUNG. All rights reserved. 8-1
Adjustment
1. After replacing an electronic part, you must make adjustments for each item by referring to the following table.
<Table. 8-1 Adjustment information>
2. Adjustment equipment
- Light source box: Light source box that supporting LV 12.
- The colour temperature specication of the Light box is 3300K.
- Innity Collimator for PUNT adjustment.
- Gray chart (18%) and DARK BOX for FLASH & AWB adjustment.
- POWER SUPPLY: 4.2V/2A
3. Adjustment program le
Save the “Adjustment” le and “cs_adj.txt” le on memory card as follows.
MAIN PCB
TOP FPCB
POPUP PCB
BARREL ASSY CIS ASSY
Firmware update O X X X
OIS CENTERING ADJ O X O O
PUNT(Auto Focus) ADJ O X O O
SHUTER CLOSE, CCD, IRIS ADJ O X O O
LENS SHADING ADJ O X O O
CIS DEFECT PIXEL ADJ (DPC) O X O O
FLASH & AWB ADJ O O O O
WIFI SETTING, MAC ADDR, SERIAL NO WRITE enter O X X X
8-1 Basic guide for adjustment
8. Adjustment
■ After replacing an electronic part, you must make changes for each adjustment item in the WB200F.
■ The following table shows the necessary adjustment item for replacing each part.
■ The camera must be xed with a tripod and levelled condition must be maintained.
Fig. 8-1