Adjustment
8-8
Copyright© 1995-2012 SAMSUNG. All rights reserved.
<Adjustment method>
1. Insert the memory card containing the adjustment le into the camera and then
entering the adjustment mode.
2. Select the Defect(CIS Defect Pixel) of adjustment menu.
3. The adjustment will automatically start.
Check the set reference level, exposure time and loop, and execute the Defective Pixel calibration.
Refer to the specication (Maximum number of defective cells) and execute the check.
Refer to the CARD WRITE information to write the number of defective cells to the data le.
4. When the adjustment is completed, the camera will automatically be turned off.
<Adjustment method>
1. Insert the memory card containing the adjustment le into the camera and then
entering the adjustment mode.
2. Select the Country Code of adjustment menu.
3. Input the 3-digit country code in the screen below.
8-7 CIS DEFECT PIXEL ADJ
Calibrate the Defective pixel of CIS for each camera.
■ In case of Wi-Fi Built-in models, MAC Address Write procedure is required after replacing Main PCB.
■ Symptom : If country is not selected after replacing Main PCB;
- Proper SNS for its country as below is not available.
- Keypad for its country when using Wi-Fi (English default)
- Wi-Fi data trasmission speed is low.
8-8 COUNTRY CODE(Wi-Fi) Input
Fig. 8-10
Country Code Setting
000
[OK] Foward [Sh] Backward [PB] Accept [MENU] Cancel
0
[Zoom] - Number increases, decreases
[OK] - Forward
[Shutter] - Backward
[Playback] - Accept
[Menu] - Cancel
To Next Page
Loading...
