Samsung WB200F - Ois Centering Adj; Punt(Auto Focus) ADJ

Copyright© 1995-2012 SAMSUNG. All rights reserved. 8-3
Adjustment
CAUTION
!
Put your camera up straight on a steady surface such as a table or anything solid that won’t move.
Don’t put your camera on a highly unstable surface. Also don’t put your camera down or hold it.
The noise may signicantly affect degrading the Gyro Sensor and Hall Sensor performance.
<Adjustment method>
1. Insert the memory card containing the adjustment le into the camera and then
entering the adjustment mode.
2. Select the OIS Centering of adjustment menu.
3. Adjustment is made automatically.
- OIS module will be operated left/right/up/down 2-3 times.
4. When the adjustment is completed, the camera will be off automatically.
8-2 OIS CENTERING ADJ
ProcesstocheckifOISperformswellornot.
<Adjustment method>
1. Refer to the following adjustment environment specication to adjust the focus.
1) Used specication of Innity Collimator.
  -SettheilluminancespecicationoftheCollimatorto6LV.
  -Maintaindistanceoflessthan1cmbetweentheendofthecamerabodytubetothelenssurfaceoftheInnityCollimator.
  -Thecameramustbexedwhiletheadjustmentismade.
Fig.8-5
Innity Collimator
Camera
Tripod
8-3 PUNT(Auto Focus) ADJ
■ Adjustment objective:AdjustmentforimplementtheperformanceofAFoptimizedbyadjustmentto
assemblydeviationofbarrel(Lens).
■ Necessary equipment: InnityCollimator