Samsung WB200F - Shutter Close, Cis Gain, Iris Adj

Copyright© 1995-2012 SAMSUNG. All rights reserved. 8-5
Adjustment
<Adjustment method>
1. Prepare the Light source box that can be adjusted to LV 12.
2. Insert the memory card containing the adjustment le into the camera and then install the camera to the
Light source box.
* Luminance specication of the Light box is LV 12.
* The colour temperature specication of the Light box is 3300K.
3. Select the Shutter Close Time of adjustment menu.
4. The adjustment process will automatically start.
 Check the number of maximum adjustments which have been set,
and adjust the Shutter close time, CMOS sensor gain, IRIS
 Carry out inspection by referring to the specications for brightness.
- The line delay and sub delay, Gain, IRIS value are adjusted to 󰘰nd the proper values
for the speci󰘰cations for brightness.
 If the result value are within spec, it is OK. Otherwise, it is NG.
r Write the adjustment value in the EEPROM by referring to the EEPROM WRITE data.
 Write the result of the adjustment value in the data le by referring to the CARD WRITE data.
5. When the adjustment is completed, the camera will automatically be turned off.
6. Liveview Gain, Capture Gain, Iris are also perform in the same way.
Fig. 8-7
Light source box
Tripod
Camera
8-4 SHUTTER CLOSE, CIS GAIN, IRIS ADJ
■ Adjust the Close timing of the device shutter by camera.
■ Because there is a deviation of shutter closing time by each set, make adjustments by each set to reduce this deviation.
■ CCD Gain item and AWB LOW are adjusted simultaneously.
Light source box