Firmware update
7-4
Copyright© 1995-2012 SAMSUNG. All rights reserved.
code partition1 partition2 partition3 User Area
Fig. 7-6
7-3 Update
♦ How to execute the rmware
The rmware is congured in the following structure.
Code area is where the execution codes to operate the camera are located, and the Partition [1:3] area is where the various resources
necessary to operate the camera are saved. Among these areas, Partition 3 area is where the Defective Pixel adjustment data and
Lens Shading adjustment data are saved.
User Area is where the setting values are saved through the menu when the user uses the camera, and the adjusted data through
integrated process is saved.
► Reference of general version:
- As the version to update the Code + Partition [1:2] area, this protects both the adjusted data saved in the User Area and
the Partition 3 area.
1. Insert the memory card containing the rmware data le and Update Script le into the camera.
* You need two les to update the rmware and the required les are rmware data le and Update Script le.
* Because all data saved on the FLASH memory will be reset when you update the rmware, back up
your data before proceeding with the update.
2. Use the AC adaptor or fully charged batteries for the power.
* You can proceed with the update only when the battery level is full (Icon showing full up to 3rd level).
3. Turn on the power of the camera.
<Table. 7-1>
DATAWB200.bin
fwup.txt
Power ON
Firmware upgrade
DSP: 1211071 -> 1211271
OIS VERSION: 1211061
SPEAR_FW_VER(0.5)
Press the Shutter button to upgrade the rmware.
To Next Page
Loading...
