15
02. Operation and setting
System setup Setting the sensor input
1. Sensor type 2. Unit of display 3. Tag name 4. Dot position
5. Sensor range 6. PV when S.OPN 7. Measurement method
Alarm signal
Setting the user screen
System initial setting
DI function and operation (Option)
Communication environment
setting
1. Ethernet communication
● Communication protocol, communication port setting, network setting, communication setting lock
● IP, Subnet mask, Gateway setting
2. Serial communication
● Communication protocol, communication speed, parity, stop bit, data length, other parameters
Setting the user screen display
1. Language set 2. Display method 3. Internal memory 4. System password 5. Paramerer password
1. Buzzer time setting 2. DI detection delay time 3. DI operation method 4. Relay output in DI detection
1. Alarm Operation 2. 4 for each channel
● Type : PV upper limit, PV lower limit, within PV range, Out of PV range, Over PV ascending
change ratio, under PV descending change ratio, within the deviation between
channels, out of the deviation error between channels, sensor circuit short
● Setting the delay time
To Next Page
Loading...