S&C Instruction Sheet 461-502 35
Appendix A
United States of America – FCC (Federal
Communication Commission)
This device complies with part 15 of the FCC rules and
regulations regarding unlicensed transmissions. Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference and (2) this device
must accept any interference.
Important: Changes or modifications not expressly
approved by S&C Electric Company could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to com-
ply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user
will be required to correct the interference at his own
expense.
Canada – ISED (Innovation, Science &
Economic Development Canada)
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Cet appareil est conforme aux normes Industry Canada
exemptes de licence RSS standard(s). Son fonctionnement
est soumis aux deux conditions suivantes : (1) cet appareil
ne doit pas provoquer d’interférences et (2) cet appareil doit
accepter toute interférence, y compris les interférences
susceptibles de provoquer un fonctionnement indésirable.
The changes or modifications not expressly approved by
the S&C Electric Company could void the user’s authority
to operate the equipment.
CAN ICES-3 (A)/NMB-3(A)
Australia/New Zealand (ACMA)
The above-mentioned product complies with the
requirements of the relevant ACMA Standards made
under the Radiocommunications Act 1992 and the
Telecommunications Act 1997. These Standards
are referenced in notices made under section 182
of the Radiocommunications Act and 407 of the
Telecommunications Act.