14 S&C Instruction Sheet 695-535
To get to the Login screen, open a compatible Web browser and enter the address:
http://sandcvista. If an error is encountered, enter the IP address http://10.1.11.58.
This will open the Login screen. See Figure 5.
There are three types of login:
Figure 5. The Vista Overcurrent Control Login screen.
• admin – The admin login should ONLY be used when initially setting up the control
or as directed by S&C, such as for installing a rmware update.
• user – The user login should be used for general access to the control when changes
to the protective settings must be made.
• View– The View mode should be the primary means of accessing the control. The
View button allows the user to view the status of the control, load currents, protective
settings, rmware revision, and to view and clear event logs. No changes to the protec-
tive settings or control settings can be made.
For more information on the types of login privileges, see the “User Access and
Privileges” section on page 9.
To log in to the control using the admin or user login, enter the appropriate login name
and password in the Username and Password fields. Then click on the Login button.
To log in to the control using the View mode, click on the View button.
See the “Logging in for the First Time” section on page 15 for more information on
setting the admin and user passwords.
Logging Into the
Control
Accessing the Overcurrent Control with a Web Browser
To Next Page
Loading...
