S&C Instruction Sheet 695-535 9
Product Overview
Three-phase fault interrupters are designed for three-phase tripping. Single-phase
tripping is not possible with three-phase fault interrupters.
The overcurrent control has three levels of access. All access levels can view the
status page, which includes the status of the control, load currents, settings, and
firmware version.
Table 1. Access Levels
Access Level Description
admin Can access the Time Overcurrent Phase Protection menus of “Interrupter 1” and
“Interrupter 2” and make settings changes.
Can access all Control Settings and make changes.
Can change admin password and user password.
Can clear Diagnostic and Trip Event Logs.
Can perform a trip test.
Can upgrade firmware.
Can perform a factory default reset.
user Can access the protective settings menus of “Interrupter 1” and “Interrupter 2” and
make changes.
Can change user password ONLY.
Can clear Diagnostic and Trip Event Logs.
View button Can view and clear Diagnostic and Trip Event Logs.
Trip Mode
User Access and
Privileges
To Next Page
Loading...
