S&C Instruction Sheet 695-535 45
External Connections
This section describes each of the external connections to the control. Included in the
following tables are terminal numbers, terminal names, and mating-connector part
numbers (where applicable.) Terminal numbers are identied by labels on the electronics
module or terminal block.
Electronics
module
Trip
outputs
Figure 33. The Trip Output connections.
Table 8. Trip Outputs●
Terminal Number (1,2) Pole Mating-Connector Part Number
1, 2 Fault Interrupter 1, Phase A Phoenix 1783999
3, 4 Fault Interrupter 1, Phase B
5, 6 Fault Interrupter 1, Phase C
7, 8 Fault Interrupter 2, Phase A Phoenix 1876194
9, 10 Fault Interrupter 2, Phase B
11, 12 Fault Interrupter 2, Phase C
● Trips are polarized.
Trip Outputs
To Next Page
Loading...
