012
Carefully extend the telescopic aerial.
Press and hold the Power button to switch on your radio.
If this is the rst time the radio is used, a quick scan of the Band III DAB channels will be carried
out. If the radio has been used before the last used station will be selected.
During the scanning process, as new stations are detected the station counter will increase and
the stations will be added to the list which is stored in the radio. The bar graph indicates the
progress of the scan.
When the scanning is completed the rst station (in numeric-alpha order 0...9...A....Z) will be selected.
If the station list is still empty after the scan, your radio will show “No stations found” for a moment.
If no signals are found it may be necessary to relocate your radio to a position giving better reception.
Press and hold the Power button to switch on your radio.
Press the Source button until the 'DAB radio' mode is selected.
Rotate Tuning control knob to step through the list of available stations.
Press Select button to select and tune to the desired station.
Use the Volume Up / Down button to set the sound level as needed. Alternatively to access the
station list using the DAB menu, press and hold the Menu button and then choose 'Station List'.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
Operating your radio – DAB
Selecting a station – DAB
If after selecting a station the station does not tune it may be necessary to relocate your radio to a
position giving better reception.
NOTE
To Next Page
Loading...
