Sangean DPR-42BT - Dynamic Range Control Settings - DAB; Station Order Setup - DAB

014
Not all DAB broadcasts use the DRC function. If the broadcast does not provide DRC information,
then the DRC setting in the radio will have no effect.
Dynamic Range Control settings – DAB
Station order setup – DAB
Dynamic Range Control (also known as DRC) can make quieter sounds easier to hear when your
radio is used in a noisy environment by reducing the dynamic range of the audio signal.
Your radio has 3 station order settings from which you can choose. The station order settings are
alphanumeric, ensemble and valid.
When in DAB mode press and hold the Info / Menu button to enter the DAB menu.
Rotate the Tuning control knob to select “DRC”.
Press the Select button to enter the DRC adjustment mode.
Rotate the Tuning control knob to highlight the required DRC setting (the default is Off).
DRC High - DRC is set as sent by broadcaster.
DRC Low - DRC level is set to 1 / 2 that sent by broadcaster.
DRC Off - DRC is switched off, Broadcast DRC will be ignored.
Press the Select button to conrm the setting.
When in DAB mode press and hold the Info / Menu button to enter the DAB menu.
Rotate the Tuning control knob to select “Station order”.
Press the Select button to enter the station order adjustment mode.
Rotate the Tuning control knob to choose “Alphanumeric”, “Ensemble” and “Valid”.
“Alphanumeric” - sorts the station list alpha-numerically 0...9 A...Z.
“Ensemble” - organizes the station list by DAB multiplex.
“Valid” - shows only those stations for which a signal can be found.
Press the Select button to conrm the required station order
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
NOTE