Sangean DPR-42BT - Manual Tuning - FM

016
Operating your radio – FM
Manual tuning – FM
When in FM mode, rotate Tuning control knob to tune to a station. The frequency will change in
steps of 50kHz.
Press the Volume Up / Down button to adjust the sound level as needed.
1.
2.
5.
6.
7.
8.
After a few seconds the display will update. The display will show the frequency of the signal
found. If the signal is strong enough and there is RDS data present then the radio will display the
station name.
When the end of the waveband is reached your radio will recommence tuning from the opposite
end of the waveband.
Press the Volume Up / Down button to adjust the sound level as needed.
To switch off your radio, press and hold the Power button.