Sangean DPR-42BT - Automatically Updating the Clock

022
Listening to music via Bluetooth streaming
Automatically updating the clock
Press and hold the Bluetooth pairing button for 2-3 seconds to disconnect with your Bluetooth
device or turn off Bluetooth on your Bluetooth source device to disable the connection. There will
be a conrmation tone sound and the “Bluetooth Pairing” will show on the display.
You can also press the Source button to select any mode other than Bluetooth mode to disable the
connection.
You may specify that the radio sets its clock from DAB or FM radio broadcasts. After a power failure
the radio will then set its clock the next time that you turn on the radio in DAB or FM mode.
Alternatively you may specify that the time is not automatically updated. In this case the clock must
always be set manually after a power interruption.
With your radio switched on, press and hold Info / Menu button to access the menu for the current mode.
Rotate the Tuning control knob to select “System Settings”. Press the Select button to enter the
system settings menu.
Rotate the Tuning control knob to select “Time/Date”. Press the Select button to enter the setting.
Rotate the Tuning control knob to select “Auto Update”. Press the Select button to enter the
auto-update menu.
Rotate the Tuning control knob to choose an update option from “from Any”, “from DAB Radio”,
“from FM” or “No Update” as required. Press the Select button to conrm your choice. The current
setting will be marked with a tick.
The DPR-42BT can memorize up to 8 sets of paired Bluetooth source devices, when the memory
exceed this amount, the earliest paring device will be over written from the device.
If your Bluetooth source device already paired with the DPR-42BT previously, the unit will memorize
your Bluetooth source device and it attempts to reconnect with a Bluetooth source device in memory
which is last connected. If the last connected Bluetooth source device is not available, the DPR-42BT
will try to connect to the second last Bluetooth source device.
1.
2.
1.
2.
3.
4.
5.
Reconnecting a previously – paired Bluetooth source device
Disconnecting your Bluetooth device