Santec PCU-110 - Page 39

Polarization Control Unit PCU-110
5-21
10) *SRE Service Request Enable Register Setting
Syntax *SRE<wsp><value>
Description Sets the Service Request Enable Register (SRER).
Parameter Setting value from 0 to 255
Response None
11) *SRE? Service Request Enable Register Query
Syntax *SRE?
Description Places the value of the Service Request Enable Register
(SRER) in the output queue.
Parameter None
Response Integer from 0 to 63, or 128 to 191.
(Values are missing since Bit 6 is always 0.)
12) *STB? Status Byte Register Query
Syntax *STB?
Description Places the value of the Status Byte Register (STBR) in the
output queue.
Parameter None
Response Integer from 0 to 255
When read out by a serial poll, the value returned is the sum
of 64 and the value of the Status Byte Register (since Bit 6 is
set in the serial poll).
Command Description Page
:POLarization Sets polarization state
5-23
:POLarization? Reads out polarization state
5-23
:POWer:UNIT Sets the power unit.
5-23
:POWer:UNIT? Reads out the power unit.
5-24
:POWer[:LEVel]? Reads out the monitor power.
5-24
:SPECial:REBoot Resets the device.
5-24
:SYSTem:ERRor? Reads out the error issued.
5-24
:SYSTem:VERSion? Reads out the version of the rmware.
5-24
:SYSTem:COMMunicate:GPIB:ADDRess Sets the GPIB address.
5-25
■
5-6-4 PCU-110 Specic Command Overview
An overview of the specic commands is shown in the following table.
Table 5-3.
PCU-110 Specic Command List