Santec PCU-110 - Page 42

5-24
PCU-110 Operation Manual
POWer:UNIT?
Syntax [:SENSe]:POWer:UNIT?
Description Reads out the power unit.
Parameter None
Response 0: dBm
1: mW
Example :POW:UNIT?
+0
The power unit is “dBm”.
:POWer[:LEVel]?
Syntax [:SENSe]:POWer[:LEVel]?
Description Reads out the monitor output power.
Parameter None
Response Range: -40dBm ~ +10dBm
Example :POW?
-5.000000E+00
The currently monitor power is -5dBm.
2) System related commands
:SPECial:REBoot
Syntax :SPECial:REBoot
Description Resets the device.
Parameter None
Response None
Example :SPEC:REB
:SYSTem:ERRor?
Syntax :SYSTem:ERRor?
Description Reads out the error issued.
Parameter None
Response Error Number (Refer to “Table 5-4. Command Error” .)
Example :SYST:ERR?
Error numbers and error messages are returned.
:SYSTem:VERSion?
Syntax :SYSTem:VERSion?
Description Reads out the version of the rmware.
Parameter None
Response The format is (4 digits) + (period) + (4 digits)
****.****