Santec PCU-110 - Page 44

5-26
PCU-110 Operation Manual
:SYSTem:COMMunicate:ETHernet:DHCP
Syntax :SYSTem:COMMunicate:ETHernet:DHCP<wsp><value>
Description Sets DHCP
Parameter 0: DHCP disable
1: DHCP enable
Response None
Example :SYST:COMM:ETH:DHCP 1
:SYSTem:COMMunicate:ETHernet:DHCP?
Syntax :SYSTem:COMMunicate:ETHernet:DHCP?
Description Reads out DHCP setting
Parameter None
Response 0: DHCP Disable
1: DHCP Enable
Example : SYST:COMM:ETH:DHCP?
→ 1
:SYSTem:COMMunicate:ETHernet:IPADdress
Syntax SYSTem:COMMunicate:ETHernet:IPADdress<wsp><value>
Description Sets IP address when DHCP is disabled.
Parameter ***.***.***.*** (*** is integer from 0 to 255)
Response None
Example :SYST:COMM:ETH:IPAD 192.168.0.1
:SYSTem:COMMunicate:ETHernet:IPADdress?
Syntax :SYSTem:COMMunicate:ETHernet:IPADdress?
Description Reads out IP address
Parameter None
Response ***.***.***.*** (*** is integer from 0 to 255)
Example :SYST:COMM:ETH:IPAD?
→ 192.168.0.1
:SYSTem:COMMunicate:ETHernet:SMASk
Syntax :SYSTem:COMMunicate:ETHernet:SMASk<wsp><value>
Description Sets subnet mask when DHCP is disabled.
Parameter ***.***.***.*** (*** is integer from 0 to 255)
Response None
Example :SYST:COMM:ETH:SMAS 255.255.255.0
:SYSTem:COMMunicate:ETHernet:SMASk?
Syntax :SYSTem:COMMunicate:ETHernet:SMASk?
Description Reads out subnet mask
Parameter None