Sanyo FWZV475F - Page 86

86
EN
TROUBLESHOOTING
Symptom Remedy
DVD
The disc tray does not open when you
press [A].
•
It may take a few seconds for the disc tray to open after you have
recorded or edited a disc. This is because the unit is adding disc data to
the disc.
“Repairing” appears on the TV
screen.
Repairing
•
Ifthereisapowerfailureorunpluggingduringrecording,nalizing,
formatting or editing (even after “Repairing” disappears), a repairing
process will begin automatically just after turning the unit on again.
It may take several minutes up to about several hours.
In a case you intend to cancel the
repairing process.
Repairing
Do you want to cancel a repairing
process? When selecting “Yes”,
the disc may not be usable.
Yes
No
•
If you intend to cancel the repairing process, press [A ] on the front
panel, then select “Yes” and press [OK]. After that, press [A] to take out
the disc. The disc cancelled during the repairing process MAY NOT
work.
VCR
Picture noise appears.
•
Head cleaning for VCR may be necessary. Refer to “Auto head cleaning”
(page 4).
•
Adjust tracking control for better picture by pressing [TRACKING K / L]
while you are playing back a cassette tape.
The cassette tape does not play back.
•
No cassette tape is inserted.
Recording does not start after you
press [REC].
•
Make sure the cassette tape has an erase-protection tab when you
record to a cassette tape. If needed, cover the hole with cellophane tape.
The remote control does not function.
•
Check if a cassette tape is in this unit.
The motor rotates even when playback
/ recording is stopped.
•
The motor may rotate for the duration of approximately 5 minutes for
efcientoperation.Thisisnotamalfunction.
Instructions continue on the next page.