Sanyo MCO-19M - Initial Settings (LCD;DAQ Parameters)

Initial settings (LCD/DAQ parameters)
1. Select LCD/DAQ Setting from the Select Tools Display, press the MENU Key to display the menu,
select OK, and press the ENTER Key.
2. The LCD/DAQ Setting Display will appear. Set the initial setting for each parameter as necessary.
・
LCD Back Color: Setting of the background color (1: Blue, 2: White)
Note:
DAQ is an external monitoring system of the chamber status. It is necessary to set the DAQ speed, DAQ
ID, and DAQ mode to use the optional communications software. Communications software is an
optional accessory. Contact a Sanyo sales representative or agent for details.
S e l e c t T o o l s ( 1 / 2 )
T e m p / C O 2 C a l i b r a t i o n
A l a r m Se t t i n g
L C D / D A Q S e t t i n g
U V S e t t i n g
K e y L o ck P W S etting
D a t e T i m e
M E N U
O K
S v c
C a n c e l
1
L C D / D A Q S e t t i n g
3
L C D B a c k C o l o r 1 ( 1 . B l u e 2 . W h i t e )
D A Q S p ee d 0 ( 0. 2400 2. 96 0 0 )
4
D A Q I D 0 ( 0 . O F F 1 - 2 5 0 )
5
D A Q M o d e 0 ( 0 . L o c a l 1 . R e m o t e )
R e m o t e A l a r m 1 ( 0 . O F F 1 . A c t i v e )
6
- 147 -
40