Sanyo MCO-19M - Effective Models; Table of Contents

Contents
㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌㻌 Page
Specifications ------------------------------------------------------- 1
- Structural specifications
- Control specifications
- Performance specifications
Dimensions ----------------------------------------------------------------- 4
Gas circuits ----------------------------------------------------------------- 5
Temperature calibration ----------------------------------------------------------------- 6
CO
2
span calibration ----------------------------------------------------------------- 7
O
2
㻌
span calibration ----------------------------------------------------------------- 8
CO
2
/O
2
zero calibration ----------------------------------------------------------------- 9
Components on PCB ----------------------------------------------------------------- 10
Connections on PCB ----------------------------------------------------------------- 11
Electric parts ----------------------------------------------------------------- 12
Wiring diagram ----------------------------------------------------------------- 13
Circuit diagram (MAIN / LCD) ----------------------------------------------------------------- 14
Control specifications ----------------------------------------------------------------- 16
Operational specifications of LCD panel ---------------------------------------------- 23
Prevention of contamination ----------------------------------------------------------------- 71
Specifications of sensors ----------------------------------------------------------------- 72
Mechanism of Double wavelength IR sensor ---------------------------------------------- 74
Water sensor ----------------------------------------------------------------- 75
Parts layout ----------------------------------------------------------------- 76
Setting procedures for optional components -------------------------------------- 77
How to install UV lamp add-on kit 䠄MCO-19UVS䠅 -------------------------------------- 81
Installation of H
2
O
2
Generator (MCO-HP) ---------------------------------------------- 87
How to install H
2
O
2
decontamination kit (MCO-HL) and Electric lock ------------- 88
How to install Roller Base 䠄MCO-18RB䠅 ---------------------------------------------- 92
How to install Automatic CO
2
cylinder changeover䠄MCO-21GC䠅 ------------- 93
How to install Automatic CO
2
density calibration add-on kit 䠄MCO-SG䠅 ---------- 101
Test data ----------------------------------------------------------------- 102
- Temperature pull-up data
- Humidity pull-up data
- Temperature change during power failure
- Temperature recovery data (30sec/60sec door open)
- Humidity recovery data (30sec/60sec door open)
- CO
2
recovery data䠄30sec/60sec door open䠅
- N
2
/O
2
recovery data䠄30sec/60sec door open䠅
- Days before CO
2
tank becomes empty
- Days before N
2
/O
2
tank becomes empty
- Temperature distribution data – 15points measured
Instruction manual ----------------------------------------------------------------- 106