Sanyo MCO-19M - H2 O2 Decontamination Process; Requirements for H2 O2 Decontamination

- 47 -
㻌
㻌
㻌
<Setting of O2 density for standard gas calibration>
㻌
㻌
䣕 䣶 䣣 䣰 䣦 䣣 䣴 䣦 䣉 䣣 䣵 䣅 䣣 䣮 䣫 䣤 䣴 䣣 䣶 䣫 䣱 䣰 䣕 䣶 䣧 䣲 䢼 䢷
䣕 䣶 䣦 䣉 䣣 䣵 䣅 䣣 䣮 䣫 䣤 䣇 䣴 䣴 䣱 䣴 䢰
䣇 䣴 䣴 䢶 䢳 䢼 䣕 䣶 䣦 䣉 䣣 䣵 䣇 䣯 䣲 䣶 䣻 䢷 䢰 䢲 䢧 䢮 䣑 䢴 䢼 䢷 䢰 䢲 䢧
䣒 䣗 䣕 䣊 䣏 䣇 䣐 䣗 䣑 䣍 䣕 䣖 䣉 䢼 䢷 䢰 䢲 䢧 䢮 䣕 䣖 䣉 䢼 䢷 䢰 䢲 䢧
㻌
㻌
䐟 Step for standard gas calibration mode
Current step in standard gas calibration is displayed.
䐠 Status of unit
Status of unit in standard gas calibration is displayed.
䐡 Error message
Error message is displayed.
䐢 Message for operator
When standard gas calibration mode is complete, the message is shown for an operator.
䐣 Density in CO2 sensor during standard gas calibration
CO2 density sensed by CO2 sensor during standard gas calibration is displayed.
䐤 Setting density of CO2 standard gas
CO2 density in standard gas cylinder is displayed.
䐥 Density in O2 sensor during standard gas calibration
O2 density sensed by O2 sensor during standard gas calibration is displayed.
䐦 Setting density of O2 standard gas
O2 density in standard gas cylinder is displayed.
ձ
ղ
ճ
մ
յ
ն
շ
ո